Bodum CHAMBORD Instrucciones De Uso página 4

– Always ensure that you pour out boiling water slowly and
carefully, taking care not to tilt the spout too rapidly.
– To prevent scalding, avoid coming into contact with the
steam escaping from the opening in the lid when the
water is being boiled or just after the kettle has switched
off. Be careful when opening the lid, if the kettle is still
hot and you wish to refill it with water.
– Boiling water can cause burns.
– Move the appliance with extreme care when it contains
hot water.
– Never immerse the item in water, remember this is an
electrical appliance.
– Only clean the appliance using a damp cloth.
– To disconnect, press the «off» button then remove plug
from wall outlet.
– Always unplug the appliance by holding the plug, not the
cord.
– Do not let cord hang over edge of table or counter, or
touch hot surfaces.
– Unplug the power cord from the wall outlet when the
kettle is not in use and before cleaning. Allow the kettle
to cool before cleaning it.
– Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or
adjustment.
– Never attempt to exchange the mains cable of the appli-
ance as special tools are required for this. To ensure
continued safety of the appliance, if the cable needs to be
repaired or exchanged, have this carried out exclusively
by a customer service workshop authorised by the manu-
facturer.
– To protect against fire, electric shock and injury to persons
do not immerse cord, plug, kettle container and power
base in water or other liquid.
INSTALLATION
– Place the appliance on a stable flat surface which is
neither hot nor near a heat source. The surface must be
dry. Keep the appliance and its mains cable out of reach
of children.
– During use, do not place the base unit on a metal tray or
a metal surface.
– Ensure that the voltage indicated on the rating plate of
the appliance agrees with the mains voltage in your area.
Connect the appliance only to a properly earthed power
point with a minimum output of 6A. (Use a residual
current device (RCD) seek the advice of an electrician.)
3