PRODUCT SPECIFICATIONS
ENGINE
Engine Type .................................................. 169cc Subaru
Cooling System .................................................. Forced Air
Starting System .........................................................Recoil
Ignition System ............................................................T.C.I.
Spark Plug .............................................. Champion RL86C
Engine Lubricant Volume........................................... 20 oz.
Fuel Volume ................................................................ 2 gal.
*Rated running watts determined by PGMA Standard G200
KNOW YOUR GENERATOR
See Figure 2.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE LEVER
The choke lever is used when starting the engine.
FUEL TANK
The fuel tank has a capacity of 2 gallons.
FEATURES
GENERATOR
Rated Voltage ........................................ 120V AC / 12V DC
Rated Amps ..................................................18.75 A / 15 A
Rated Running Watts* ........................................... 2,250 W
Rated Starting Watts ............................................. 2,800 W
Rated Frequency ....................................................... 60 Hz
DIMENSIONS
Length ................................................................. 17-1/2 in.
Width ................................................................... 23-1/3 in.
Height .................................................................. 16-1/2 in.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
OIL CAP
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAINAGE BOLT
When changing the engine lubricant, the oil drainage bolt is
loosened to allow old engine lubricant to be drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz outlets:
two 120 Volt AC, 20 Amp GFCI receptacles, and one 12 Volt
DC outlet. These can be used for operating appropriate ap-
pliances, electrical lighting, tools, and motor loads.
RECOIL STARTER GRIP
The recoil starter grip is used (along with the engine switch)
to start the generator's engine.
Page 10 — English