Descargar Imprimir esta página

Monogram ZWL1126 Manual Del Propietário página 20

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Save time and money! Review the charts on the following pages first and you may not need to call for service.
Problem
Oven will not come on
Control panel lighted, yet
oven will not start
"ERR" appears on display
"LOC" appears on display
Food amount too large for
sensor reheat
"FOOD" appears on
display
"PF" appears on display
"F3" appears on display
THINGS THAT ARE NORMAL WITH YOUR MICROWAVE OVEN
the door.
incomplete. High vapor pressure may push out the door
to trip door switch off resulting in paused operation.
Check that the door is closed and press start/pause
button to continue cooking cycle.
power levels other than high.
20
Possible Causes
A fuse in your home may be blown or the circuit breaker tripped. Replace fuse or reset circuit breaker.
Unplug your microwave oven, then plug it back in.
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
Door not securely closed.
Start/Pause must be pressed after entering cooking selection.
Another selection entered already in oven and
Make sure you have entered cooking time after pressing Cook Time.
was pressed accidentally. Reset cooking program and press Start/Pause.
Make sure you entered food weight after pressing Defrost Weight.
Oven was paused accidentally. Press Start/Pause to restart the cooking program.
During a Sensor Cooking program, the door was opened before steam could be detected. "ERR" will
display until
is pressed.
Steam was not detected in maximum time. Use Cook Time to heat for more time.
The control panel has been locked. (When the control panel is locked, "LOC" will be displayed.)
Press and hold
for about 3 seconds to unlock the control panel.
Sensor Reheat is for single servings of recommended foods. Use Cook Time for large amounts of food.
The control detected that the door has not been opened (food/beverage has not been placed inside).
A Power Failure has occurred. Press
happen if liquid is on the control panel. Dry the control panel thoroughly after cleaning.
not pressed to cancel it.
to clear the display.
microwave. Similar to the interference caused by other
small appliances, it does not indicate a problem with the
microwave. Plug the microwave into a different electrical
circuit, move the radio or TV as far away from the
microwave as possible, or check the position and signal
of the TV/radio antenna.
49-7000167 Rev. 0

Publicidad

loading

Este manual también es adecuado para:

Zwl1126srss