IPC CT110 ECS Manual De Instrucciones página 55

•
Speed potentiometer (fig. A, ref.
forwards and backwards
• Solution flow regulation button (fig. A, ref. 3): there are five operating modes
•
STANDARD
•
AUTOMATIC
•
ECONOMY.
•
MICROFIBRE (MICRO SCRUB / ECS MACHINE)
•
CHEM-DOSE
• Solution/concentrated detergent flow quantity variation buttons (fig. A, ref. 2):
vary the flow of solution/concentrated detergent
• Display (fig. A, ref. 6):
•
displays the quantity of concentrated detergent when enabled.
•
displays alarm codes.
•
displays hour counter.
• Horn button (fig. A, ref. 12):
• Suction button (fig. A, ref. 9): enables/disables the suction function. If you press this
button for more than five seconds, the suction motor starts working even without the
operator on board.
• Brush button (fig. A, ref. 8):
•
STANDARD MACHINE, enables/disables operation of the head.
•
MICRO SCRUB / ECS MACHINE, enables/disables operation of the head. Hold
the button down for at least 3 seconds to select the operating mode, "BRUSH-
PAD" with brushes/abrasive disk, or "MICROFIBRE" with microfibre disk.
• Solution tank level indicator: (fig. A, ref. 14): when there is not enough water in the
solution tank, the LED comes on and the head and solenoid valve are turned off.
• Collection tank level indicator (fig. A, ref. 11): when the collection tank is full, the
LED comes on and after a few seconds the suction motor is turned off.
• Head pressure variation buttons (fig. A, ref. 7): vary the pressure of the brushes on
the floor
•
Motor drive board indicator (fig. A, ref. 15): indicates the status of the motor drive
board (see paragraph 10.3)
•
Disk release button (fig. A, ref. 16): MICRO SCRUB / ECS MACHINE, enables
automatic release of the microfibre disk, brush or abrasive disk from the head.
6.2. Mounting and adjusting the squeegee
The squeegee (fig. B, ref. 6) is responsible for the first phase of drying.
To mount the squeegee on the machine, proceed as follows:
1) insert the sleeve of the suction hose (fig. E, ref. 1) fully into the squeegee;
2) slacken the two knobs (fig. E, ref. 2) at the centre of the squeegee;
3) insert the two threaded pins into the slots on the support (fig. E, ref. 3)
4) fix the squeegee by tightening the two knobs (fig. E, ref. 2)
The squeegee blades scrape the film of water and detergent from the floor and prepare
the way for perfect drying. With time, the constant rubbing makes the edge of the blade in
contact with the floor rounded and cracked, reducing the drying efficiency and requiring it
to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear
blade bends during operation by about 45° with respect to the floor at every point. Adjust
the angle of the blade during operation by regulating the height of the two wheels
positioned in front of/behind the squeegee.
13): regulates the maximum speed of the machine
ENGLISH
13