IPC CT110 ECS Manual De Instrucciones página 61

Pushing and pulling the machine:
When the drive cannot be used, to push or pull the machine easily, you must block the
electromagnetic brake by screwing up the screws (fig. F, ref. 1) .
After moving the machine, unscrew the screws to release the electromagnetic brake.
If the screws are not unscrewed, the electromagnetic brake remains inactive.
Never turn the machine on with the screws (fig. F, ref. 1) screwed up (brake
deactivated).
If the machine is not used for some time, remove the squeegee and brushes (or abrasive
disks), wash them and put them away in a dry place (preferably in a bag or wrapped in
plastic film) away from dust.
Make sure the tanks are completely empty and perfectly clean.
Completely recharge the batteries before storing them. During long periods of inactivity,
you should charge the batteries regularly (at least once every two months) to keep them
constantly at maximum charge.
If you do not charge the batteries regularly, they may be irrevocably damaged.
8.
The batteries give off flammable fumes. Put out all fires and hot embers before
Perform the operations described above in a ventilated room.
8.1. Procedure for charging using the battery charger installed by the
Manufacturer
• Raise the seat (fig. B, ref. 8) and connect the battery charger mains power cable (fig. C,
ref. 7).
8.2. Procedure for charging using an external battery charger
• Raise the seat (fig. B, ref. 8) and connect the battery charge connector to the red
connector (fig. C, ref. 4).
• Turn the battery charger on
In the case of gel batteries, use a charger specific for gel batteries only.
• Charge the batteries as described in the battery charger manual;
 IMPORTANT
7.
PERIODS OF INACTIVITY
 IMPORTANT
BATTERY MAINTENANCE AND CHARGING
! DANGER
Do not check the battery by sparking.
checking or topping up the batteries.
 IMPORTANT
ENGLISH
19