Publicidad
Idiomas disponibles
Idiomas disponibles
using power tools in employment, an
estimation of vibration exposure should
consider, the actual conditions of use and
the way the tool is used, including taking
account of all parts of the operating
cycle such as the times when the tool is
switched off and when it is running idle in
addition to the trigger time.
After use
When not in use, the machine should
be stored in a dry, well ventilated place
out of reach of children.
Children should not have access to
stored machines.
When the machine is stored or
transported in a vehicle it should be
placed in the boot or restrained to
prevent movement following sudden
changes in speed or direction.
Inspection and repairs
Before use, check the machine for
damaged or defective parts.
Check for breakage of parts and any
other conditions that may affect its
operation.
Do not use the machine if any part is
damaged or defective.
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace
any parts other than those specified in
this manual.
(Original instructions)
Additional safety instructions for
grass trimmers
Warning! Cutting elements continue to
rotate after the motor is switched off
Be familiar with the controls and the
proper use of the machine.
Before use, check the power supply
cord and extension cord for signs of
damage, ageing and wear.
If a cord becomes damaged during
use, disconnect the cord from the
mains supply immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Do not use the machine if the cords
are damaged or worn.
Before using the machine and after
any impact, check for signs of wear or
damage and repair as necessary.
Always ensure that the ventilation slots
are kept clear of debris.
Wear stout shoes or boots to protect
your feet.
Wear long trousers to protect your legs.
Before using the machine, check that
your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the machine in the upright
position, with the cutting line near the
ground. Never switch the machine on
in any other position.
Do not overreach and to keep your balance
at all times. Always be sure of your footing
on slopes and walk, never run.
Do not work on steep slopes. Work across
the face of slopes, not up and down.
Move slowly when using the machine.
ENGLISH
.
7
Publicidad
