Publicidad
Start Up
Motor Start Up
A
• Set the chainsaw onto a leveled ground where the bar
and change make no contact with the ground or any
other object.
• Firmly hold the front handle with your left hand, set the
right foot onto the rear handle base (A).
• Pull the chain brake backwards to double check it is in
the functioning position ( see page 8).
• If the chain starts while the brake is
CAUTION
activated the chainsaw may be seriously damaged.
• Set the switch into the ON position (B).
• Press completely and release the starter choke 6 times
(C).
• Pull the choke lever all the way out (D).
• Pull the jack-line (E) until the motor seems to start, but
no more than 3 times if the environment temperature is
B
D
higher than 50 °F. If the temperature is lower, pull the
jack-line until the motor starts.
• EPush the choke lever to the bottom (F).
• Pull the jack-line back (E) until the engine starts.
• Once the motor starts leave it running 30 seconds in
that position.
• Press and release the throttle trigger to run the motor
idle (G).
• The chainsaw is now ready to cut. Hold it by both
C
handles in the right position (see page 5) and lift it to start
C
working.
D
x6
F
G
12
ENGLISH
Publicidad
