Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting (Rack)
4-Post Mounting
1
The included plastic pegs
support the empty rackmount shelves
while the permanent hardware is installed.
Insert a peg near the center of the front
and rear bracket of each shelf as shown.
(Each front bracket has 6 holes and each
rear bracket has 3 holes.) The pegs will
snap into place.
After installing the pegs, expand each shelf
to match the depth of the rack rails. The
pegs will fit through the square holes in the
rack rails to support the shelves. Refer to
the rack unit labels to confirm that the
shelves are level in all directions.
Note: The support ledge of each shelf must face
inward.
2
Secure the shelves
permanently using the included screws and
cup washers
C
washer between the screw and the rack so
that the screw enters the wider opening of
the cup washer first.
Place 4 screws total at the front and
4 screws total at the back.
Tighten all screws before proceeding.
Warning: Do not attempt to install the
UPS until the required screws are
inserted and tightened. The plastic pegs
will not support the weight of the
equipment.
3
Attach the UPS mounting brackets to the
forward mounting holes of the cabinet using
the hardware included with the UPS. The
mounting bracket "ears" should face
forward. (Some equipment may have pre-
installed or integrated mounting brackets.)
4
With the aid of an assistant (if necessary),
lift the UPS and slide it into the shelves.
Attach the equipment mounting brackets to
the forward mounting rails with user-
supplied screws and washers
screws securely.
18-01-271-933440.indb 6
will temporarily
A
B
to the mounting rails
B
as shown. Place the cup
. Tighten all
D
B
A
1
B
C
2
3
D
4
6
A
C
D
1/25/2018 3:23:18 PM
Publicidad
