Metabo HPT NR 3690DC Instrucciones De Seguridad Y Manual De Instrucciones página 27

NOTE
● If all warnings and instructions are followed,
safe operation is possible with all two systems:
FULL SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
● After nailing:
1) remove battery from the Nailer;
2) remove all nails from the Nailer;
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth,
be sure that the Nailer is always held fi rmly against the
workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
Remove the battery from the Nailer.
If nails are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in half-turn increments.
Too Deep Turn Adjuster
Too Shallow
Battery
Flush
Turn Adjuster Flush
If nails are driven too shallow, turn the adjuster to the
deep side.
Stop turning the adjuster when a suitable position is
reached for a nailing test.
Connect the battery to the Nailer.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
Remove the battery from the Nailer.
Choose a suitable position for adjuster.
USING THE HOOK
● When using the hook, turn off the power
switch (green light "OFF"). Pay suffi cient
attention so that the main equipment does
not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
(1) Securely hold the main unit and remove the screw
using an allen wrench.
(2) Remove the hook and hook plate.
English
WARNING
27