Stiga SRC 550 RG Instrucciones De Uso página 18

ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
EN
have used oil deposits, or use the authorized deposits according to your local authority regulations.
GARAGING AND SCHEDULED MAINTENANCE (Fig. 15)
Keep attention that all the nuts, screws and bolts are tightened in order
to guarantee a good machine working on safety conditions. Leave the machine to cool before garaging anyhow don't room it if the tank still contains
some fuel as the vapours could reach some blazes or sparks. The fuel tank is to be drained outdoors only. To lower the fire danger, keep the engine,
the silencer and the fuel area free from leaves, grass or greasy substances. Periodically check the tightness of the handlebar (1) to the support (2). If
the tightening is not guaranteed, please lower the lever (3) and tighten the nut (4).
DESCRIPTION OF CONTROLS (Fig. 14)
1. Throttle lever - 2. Hoeing gear control lever (safety feature) - 3. Reversing lever - 4. Tilling
adjustment spur (single position) - 5. Cultivator blade (with enlargement) - 6. Knobs handlebar/frame - 7. Handlebar - 8. Transport Wheel - 9. Hoe
shield - 10. Pull-out handle (self-winding device) 11. Motor – 12. Lock/release lever for handlebar – 13. Handlebar support
TECHNICAL SPECIFICATION
Engine: consult the specific publication for information. Working width 50 cm. The highest speed of rotation of
the tiller is about 120 R.P.M. Transmission : single speed + reverse speed. Weight of the complete motor-hoe is 42 kg. Max length: 1,3 m. Max width:
0,50 m. Height: 1,10 m. Package dimensions: long 80 cm - wide 53 cm - high 69 cm.
NOISE AND VIBRATION LEVEL
Measured sound power level with En709, Lwa = 94,3 dB (A). Handlebar vibration in compliance with EN 709
and ISO 5349. Level max detected = 18 m/s².
ACCESSORIES:
Ridging plough.
18