Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
M6
Adjust the claws with the wing nuts (A) according to
the trunk diameter to obtain the most comfortable
angle of the control levers.
1
2
16
4
B
4
A
39/120
5.3. START-UP
5.3.1. PLACEMENT OF THE MACHINE
Make sure you install the machine on a stable surface
and in a vertical position in an area away from a wall
and where you will have enough room to be able to
work.
5.3.2. CHECKPOINTS BEFORE COMMISSIONING
The voltage and current supply must comply with the
indications on the rating plate. Before starting work,
make sure that the appliance operates correctly and
its operation is safe.
Do not use machine is if it is damaged or incorrectly
regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user, for the machine and for persons, animals and
things that may be around.
Check:
- The machine completely and look for loose and
damaged parts (screws, nuts, etc.).
- That the moving parts of the machine are not in
contact with any other object.
Tighten, repair or replace everything you need before
using the machine.
Do not use any accessory on this machine outside of
those recommended by Garland since its use could
result in serious injury to the user, machine, and the
people, animals and things close to the machine.
Check the oil level and make sure that it is between
the two marks on the dipstick that can be found under
the oil plug (9) input. If it is below the lowest level you
should refill the oil.
English
Publicidad
