Craftmade MOD60 Guia De Instalacion página 8

7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate 12 blade attachment screws/washers
in a hardware pack. Slide blade through one
of the narrow, rectangular openings on
motor housing, aligning holes in blade with
holes in blade arm located on the underside
of the motor housing. (Be sure to install
blades with ridged-side facing up and flat
side facing the floor). Insert 3 blade
attachment screws/washers with fingers first
and then tighten screws securely with a
Phillips screwdriver. Repeat for remaining
blades.
Note: Tighten blade attachment screws
twice a year.
canopy
screw
page 7
hanging
bracket
screw
canopy cover
blade
arm
blade
blade attachment
screws/washers