Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL
This product, installed in accordance with this guide, complies with EN 12453 and EN 13241-1 standards.
The instructions referred to in the product Installation and Operating manuals are intended to meet the requirements of
property safety, personal safety and the above-mentioned standards.
Failure to comply with these instructions releases Somfy from any liability for damage that may be entailed.
We, Somfy, declare that this product is compliant with the essential requirements and other relevant stipulations of
directive 1999/5/EC. A compliance declaration is available from the following address www.somfy.com/ce (Ixengo_L).
This product can be used in the European Union and in Switzerland.
SAFETY INSTRUCTIONS
Warning
Important: Please comply with all instructions, for incorrect installation may cause serious injury.
Safety instructions
Before installing the motor drive system, make sure that the driven part is in good working order, that it is correctly
balanced and that it opens and closes correctly.
Ensure that danger areas (where pinching, cutting, trapping may occur) between the driven parts and fi xed surrounding
parts due to the opening motion of the driven part are avoided.
Retain a clear 500 mm space behind each gate section when the gate is fully opened.
Any switch that does not lock into position (interphone, key switch, etc.) must be located in plain view of the driven part
but away from the moving parts.
Any switch installed must be at a minimum height of 1.5 meters and not be accessible to the public, except if it works
with a key.
Ensure that the motor drive system cannot be used with gate section including a wicket gate inhibiting motion
(unless the motor drive cannot operate with the wicket gate open).
After installation, make sure that the mechanism is correctly adjusted and that the protection system and any manual
release mechanism operate correctly.
Permanently affi x the label describing the manual release mechanism close to its operating mechanism.
Wear protective glasses while performing drilling work.
To operate, the Ixengo L system requires a 230 V - 50 Hz mains supply. The electric power line:
•
must be solely reserved for use by the Ixengo L,
•
must have a minimum wire cross section of 1.5 mm
•
must be provided with protection (a 10 A fuse or circuit breaker) and a residual current device (30 mA),
•
must be fi tted with an omnipolar disconnection mechanism,
•
must be installed in line with applicable electrical safety standards.
We recommend providing the installation with a surge arrester (in compliance with standard NF C 61740, with a
maximum residual voltage of 2 kV).
2
,
2
Copyright © 2008 Somfy SAS. All rights reserved.
Copyright © 2008 Somfy SAS. All rights reserved.
Publicidad
