Publicidad
Idiomas disponibles
Idiomas disponibles
c
lEaninG anD mainTaininG ThE appliancE
Vacuuming with the 2-in-1 tool or crevice nozzle
TIP: The 2-in-1 tool or the crevice nozzle can also be used without the suction tube in order to vacuum
furniture, for instance.
1.
Attach the 2-in-1 tool or crevice nozzle to the suction tube.
2.
Press the On/off switch to switch on the appliance.
The appliance vacuums in Eco mode.
–
The LEDs on the rechargeable battery light up.
–
3.
If necessary, press the mode selector switch again to select a different operating mode.
Press 1x to activate Middle mode.
–
Press 2x to activate Power mode.
–
Press 3x to activate Eco mode again.
–
4.
Vacuum the floor.
5.
Press the On/off switch to switch off the appliance.
6.
Empty and clean the dust container ("Cleaning the dust container and cyclone unit" on page 27).
TIP: The LEDs start to flash independently of the attachment when the battery charge is running low.
The appliance switches off automatically when the battery charge is too low. Charge the rechargeable
battery ("Charging the rechargeable battery" on page 24).
5 Cleaning and maintaining the appliance
For additional information on all cleaning and maintenance tasks, see
illustrated Quick Start Guide.
Cleaning the appliance
1.
Make sure that the appliance is switched off and is not on charge.
2.
Wipe the housing with a slightly damp cloth and then rub it dry.
TIP: Do not use any sharp, abrasive cleaning agents or hard brushes for cleaning.
Emptying the dust container
The dust container can only hold a limited quantity of dirt. For this reason, empty the dust container after each
cleaning procedure or if the dust reaches the MAX mark.
1.
Make sure that the appliance is switched off and is not on charge.
2.
Open the flap on the underside of the dust container.
3.
Empty the dust container into a waste bin.
4.
Close the flap on the underside of the dust container again.
26
Publicidad
