Publicidad
Idiomas disponibles
Idiomas disponibles
4.
From the front of the assembly, line up the
tabs on the upper grass catcher cover with
the tabs at the front of the upper chute
support. Slide the hinge pin through the
slots beginning at the right side upper chute
support of the mounting tabs, as in Figure
4-14. Push the pin all the way in until it reaches
the end-stop.
Figure 4-14
NOTE: The pin clips into place and is secured
by a tab on each side of the bagger cover.
5.
Swing the upper grass catcher cover down to
close the attachment. pushing in on the rear
right-side and rear left-side tabs and lock them
into place under the notches on each side.
Ensure a secure, snug fit. See Figure 4-15.
Figure 4-15
6.
Open the bagger cover by pushing in on the
tabs and lifting the upper grass catcher cover
See Figure 4-16.
Figure 4-16
8
S
4 — A
ection
SSembly
7.
Install both grass bag assemblies, with the
tight mesh sides facing forward, onto the bag
support brackets by inserting the front edge
in first, as shown in Figure 4-17, and setting the
back edge down until it fits into the assembly.
Installing the Deck Chute
1.
With the tractor's discharge chute raised up
and held open (1), install the chute elbow by
placing the chute elbow mounting rod into
the hole provided in either your deck wheel
bracket or chute mounting tab (2), as shown in
Figure 4-18.
2.
Secure the chute elbow to the deck using a
wing knob (720-04122) from hardware pack
689-00312. See Figure 4-19.
NOTE: If present, remove the protective cap
off of the mounting stud on the mowing deck
as shown in the upper inset of Figure 4-19.
& i
nStAllAtion
1
2
Figure 4-17
1
2
Figure 4-18
1
2
Figure 4-19
IMPORTANT! Be certain that the bottom of the
discharge chute is located inside of the lip of the deck
opening, as shown in Figure 4-20.
Figure 4-20
Installing the Upper Chute Tube
1.
Thread the upper end of the chute tube
securely into the upper chute support. There
are two tabs on the lower inside part of the
upper chute support to allow for secure
threading. See Figure 4-21.
NOTE: The chute tube and upper chute
support are left-hand threaded. Thread
counterclockwise until secure.
Figure 4-21
2.
Lift by the handles at the bottom of the chute
tube. Slide the chute tube over the chute
elbow mounted on the cutting deck, as shown
in Figure 4-22.
2
1
Figure 4-22
3.
Make sure the connection is secure and there
are no gaps between the chute tube and the
chute elbow.
4.
If open, close the grass catcher cover prior to
mowing.
Publicidad
