Dremel 8240 Instrucciones De Funcionamiento Y Seguridad página 21

1605A000BA 11-21 8240.qxp_8240 11/9/21 1:05 PM Page 21
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with
sanding bands.
and disconnect the plug from the power
source or the battery pack from the tool
before changing accessories. Such
preventative safety measures reduce the
risk of starting
accidentally.
Always make sure accessory is properly
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead
to personal injury or property damage.
To load accessory:
1. As indicated, place two fingers
underneath the mandrel and pull firmly
up. This will place the EZ Drum™ in the
"unlocked" position (Fig. 1).
2. Keeping two fingers beneath the
mandrel, slide the sanding band down
until the entire blue mandrel is covered
(Fig. 2).
3. To return to "locked" position, press
firmly down on the top of the mandrel
(Fig. 3).
Removing the sanding band on
the mandrel:
1. Place two fingers underneath the
mandrel and pull firmly up. This will
place the EZ Drum™ in the "unlocked"
position (Fig. 1).
2. Sanding band will now easily slide off
mandrel (Fig. 2). Do not squeeze
sanding band when removing from EZ
Drum™ mandrel. This can lead to rubber
band pulling off mandrel and becoming
inoperable.
EZ Drum Operating Instructions
™
Always make sure the
rotary tool is "OFF"
the power tool
FIG. 1
FIG. 2
FIG. 3
21