Publicidad
Idiomas disponibles
Idiomas disponibles
Emptying the dirty water tank
dirty water tank is designed to inhibit further operation of the vacuuming
system when the tank is full. It is possible to recognize when the
this situation, the operator must stop the machine and empty the dirty
water tank, proceeding as follows:
•
•
Take the machine to the disposal area.
•
separate the dirty water tank from the frame.
•
•
Drive adjustment
The machine is equipped with a special mechanical drive device that
movement.
The driving force produced by the device can be varied by turning the
colour, one green and the other yellow:
•
turning the knob to the position that exposes the green sector, the
driving force is increased.
•
turning the knob to the position that exposes the yellow sector, the
driving force is decreased.
To make the adjustment, proceed as follows:
•
•
Remove the dirty water tank and the detergent tank and set them
tank" and "Emptying the dirty water tank".
•
Elevate the brush/motor by taking up the weight with one hand,
position desired.
Finishing work
•
•
Empty the dirty water tank and rinse with clean water, referring to
the section "Emptying the dirty water tank".
•
Empty the detergent solution tank, referring to the section
"Emptying the water/detergent tank".
•
Stow the machine in the parking position, referring to the section
"Selection of parking position".
EN
1
1
Fig.25
1
Fig.26
Fig.27
Fig.28
1
19
Publicidad
