Toshiba RAV-HM301MUT-E Manual Del Propietário página 51

6
Adjustment of wind direction
To improve the cooling / heating performance,
change the louver angle for each operation.
Air characteristics: Cool air falls, and warm air
rises.
CAUTION CAUTION
Point the louver horizontally during cooling
If pointing downward for cooling, dew may form on the
surface of the air discharge or louver and may drop
down.
NOTE
• If pointing horizontally for heating, the room
temperature may be uneven.
• Do not handle the louver manually. Doing so may
cause a failure. Use the remote controller to adjust the
angle.
To set the louver direction and auto swing
1
Push the Menu button several times and select
the wind direction mode to blink the wind
direction.
2
Push the setting button several times to display
the louver direction as shown in the figure
below.
• If you do not push any button for 30s, the wind
direction mode finishes.
▼For heating
The louver can be adjusted to six steps.
Point the louver downward. If not pointing downward,
hot air may not reach the floor.
Initial (1) (2) (3) (4) (5)
Operation mode Available directions
HEAT, FAN (1) ↔ (2) ↔ (3) ↔ (4) ↔ (5) ↔ (6)
99-EN
▼For cooling
The louver can be adjusted to four steps.
Point the louver horizontally. If pointing downward, dew
may form on the surface of the air discharge port and
may drop down.
If a louver lock setup is carried out in the position of (1),
fan speed will be restricted for prevention of ceiling
contamination.
Initial (1) (2) (3) (4)
(Swing)
Operation mode Available directions
COOL, DRY (1) ↔ (2) ↔ (3) ↔ (4)
▼For fan
The louver can be adjusted to six steps.
Select a wind direction.
■
Auto swing
The SWING indicator is displayed and the louver
begins swinging.
Repeat
(6)
(Swing)
▼When cooling
Point the louver horizontally.
NOTE
• When stopped, the louver closes automatically.
• The louver automatically becomes horizontal or closed at the start of heating operation, defrosting operation, or when
the set temperature becomes the same as room temperature. If you set the swing or wind direction at this time, the
remote controller display will be the setting, but the louver will not move. When the normal heating operation that
blows warm air is started, the louver will be in the set wind direction.
• When the defrosting operation is performed during heating, the louver automatically closes to reduce the cold air
falling from the indoor unit.
• If the heating operation is performed less than 12 hours after the circuit breaker is turned on when the outside
temperature is low, the louver may automatically close immediately after the start of heating operation to reduce the
loss of cold air.
■
Information
The following functions require a connection with the RBC-AMTU*** and
RBC-AMSU*** remote controller. For details, consult the dealer where you
purchased this product.
• Individual unit selection during group operation
• Individual setting of louver position (wind direction)
• Swing type setting
• Louver lock (no swing) setting
– 50 –
▼When heating
Point the louver downward.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
100-EN