GreenWorks STF407 Manual Del Operador página 8

EN
9 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1 START THE MACHINE
1. Pull back on the lock-out button (1) and pull the trigger
(2). Once the machine is running you can release the
lock-out button.
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE DEPTH OF CUT
1. Remove the battery pack.
2. Loosen the depth adjustment knob to increase or decrease
the depth.
1
IMPORTANT
WARNING
1
2
English
Depth Adjustment Knob
3. Adjust the depth so that the blade barely touches the
ground when the machine is held in a normal operating
posture.
4. Tighten the depth adjustment knob.
5. Standing in a normal working position, check the depth of
cut again and correct if necessary.
6. Replace the battery pack once all adjustments are
complete.
9.4 REPLACE THE BLADE
If the blade worn out, replace it with a new one (not
provided).
1. Use a metal rod (1) to fix the blade.
2. Remove the nut (2) by turning it clockwise with the
wrench (4) provided.
3. Remove the washer (3).
8
Wheel
Blade
NOTE