Publicidad
Idiomas disponibles
Idiomas disponibles
FR
6. OPERATION
ES
Switch on and o
PT
1. To turn the sander on, push the O/I switch (1) forward.
2. To stop the sander, push the O/I switch (1) backward.
IT
EL
NOTE: Always lift the sander from the work before switching on or switch o .
PL
Sanding
RU
The sander can be used for most sanding operations on materials such as wood, plastic,
metal and painted surfaces.
KZ
UA
RO
Where possible, secure smaller workpiece to prevent them from moving under the sander.
EN
Lower the sander in contact with the workpiece without pressure and then start the sander.
Move the sander slowly over the surface of the workpiece in a circular or curved motion with
an even, moderate pressure.
If there are still scratches on your work after sanding, try either of the following:
- Go back to a coarser grit and sand the marks out before recommencing with the original
choice or,
- Try using new sanding sheet of the same grit to eliminate the unwanted marks before
progressing to a ner grit and nishing the job.
160
WARNING : Don't use this machine on plaster.
Wear safety goggles and dust mask.
Publicidad
