Descargar Imprimir esta página

Medistrom Pilot 24 Lite Manual Del Producto página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 2 – Connecting Pilot-12 Lite to PAP Device
Stand-by Mode
If the PAP device has been connected but not used within 10 min (or the PAP device is
turned off for 10 min), the Pilot-12 Lite will go into Stand-by Mode to conserve power.
To wake the Pilot-12 Lite press the Multi Function Button.
Charging Pilot-12 Lite
Follow STEP 1 above. Charge times for the Pilot-12 Lite via the Phillips Respironics
System One S60 or DreamStation AC adapter is approximately 2-3 hours. Charge time
via other compatible power adapters may vary.
Using Pilot-12 Lite as a Portable Battery with a compatible PAP device
Follow STEP 2 above. Run times will vary based on prescribed pressure, patient
breathing pattern, mask seal, use of any additional features or attachments such as
pressure relief, heated humidifier and heated tubing.
NOTE: For optimal run times while using your Pilot-12 Lite with a compatible PAP
device, please disable and/or detach the humidifier and heated tubing and ensure
that you are not experiencing excessive mask leak. Using your PAP device's humidifier
and heated tubing while using the battery as a backup power supply may cause a short
interruption when mains power is lost and the battery takes over.
ATTENTION! Mask leaks or high PAP pressures can greatly decrease run times.
Capacity: 95Wh
Cell Type: LG Industrial grade genuine rechargeable lithium ion cells
Rated Input: 12V, 60W(NORMAL) 80W(MAX)
Rated Output: DC 12V, 6.5A
USB Out: 5V, 2.5A
Life Span: Over 500 full charge/discharge cycles
Case: Aluminum
Dimensions: 17cm x 9cm x 2cm, Weight 1.3lbs
Power Gauge: 4 stage Charge Level Indicator Lights
Recharge time: 2-3 hours via Respironics DreamStation AC Adapter
(charging via other compatible adapters may be longer)
Section 1.7 Pilot-12 Lite Specifications
Plug the L-shaped yellow tipped end of
the DC Out Cable for Phillips Respironics
DreamStation into the DC Out Port of your
Pilot-12 Lite and plug the other black tipped
circular end into the power connector port
of Respironics DreamStation PAP Device.
Once the Pilot-12 Lite is connected to your
PAP device, the Charge Level Indicator Lights
will turn on briefly and then the On Indicator
Light will turn solid blue. At this point your
PAP device will show that it is receiving
power. If your PAP device is not receiving
power, please check the cable connections
and press the Multi Function Button.
7

Publicidad

loading

Este manual también es adecuado para:

Pilot-12lite