EGO PH1400-FC Manual Del Usuario página 34

PROBLEM
Pole saw does
not cut properly.
Bar and chain
running hot and
smoking.
34
POLE SAW ATTACHMENT — PSA1000/PSA1000-FC
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
Check chain tension for over
tightened condition.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
SOLUTION
◾
Remove the battery pack and readjust
the chain tension, following the
section "ADJUSTING THE CHAIN
TENSION".
◾
Sharpen the chain cutters, following
the section "How to Sharpen the
Cutters".
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and replace
the chain following the section
"REPLACING THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil tank if
necessary.
◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾
Remove the battery pack and
re-tension the saw chain; see the
section "ADJUSTING THE CHAIN
TENSION".
◾
Filling bar and chain lubricant.
◾
Clear the debris in the groove.