Philips AVENT SCD833 Manual Del Usuario página 24

24
English
HOW TO USE / CONNECTING THE UNITS
What happens during a
power failure?
Why can the charging
time of the parent unit
exceed 3 hours?
Why do I need to keep
the baby unit and its
cord at least 1 meter/
3.5 feet away from my
baby?
What is the difference
between the various
user modes on the
parent unit: Video,
Audio, VOX and ECO?
As the parent unit works on a rechargeable battery, the parent unit
continues to work if the battery is sufficiently charged. However, the baby
unit stops working because it has no rechargeable battery and only works
on a mains power. The parent unit will give a beeping sound to indicate that
the link with the baby unit is lost.
When mains power is restored, the connection between the parent unit and
the baby unit will automatically be established.
The parent unit may be switched on during charging. Switch off the parent
unit during charging to reduce the charging time. When the display of the
parent unit is constantly on, charging of the parent unit will take more time.
Perhaps temperature has exceeded the charging tolerance that could
potentially cut off the charging circuit as a safety protection mechanism. To
resume charging, move the charging station away from any heat sources
such as radiators, heat registers, stove or other appliances (including
amplifiers) that produce heat.
To avoid strangulation with the cord and for optimal sound detection,
always place the baby unit and its cord at least 1 meter / 3.5 feet away from
the baby.
See below list for an explanation on the available modes on your baby
monitor.
* Video mode: the screen and sound of the parent unit are always on.
* Audio mode: only audio will be activated. The display of the parent
unit switches off when AUDIO mode is activated. The link light shows
that the parent unit is still on and connected to the baby unit. All normal
correspondence with the baby unit is possible via the talk back, lullaby and
sensitivity buttons.
* VOX mode: The display and sound of the parent unit switch off if there
is no sound detected for 20 seconds (or not enough sound above the
sensitivity setting). Both display and sound will be activated immediately
when your baby cries and the sensitivity threshold is passed. When the
sound drops below the sound threshold, the video will remain active for
20 seconds. When one of the control buttons is pressed (brightness or
volume), the device shall display video for roughly 5 seconds. Also the
lullaby menu is accessible.
* ECO mode: The display and sound of the parent unit switch off when no
sound is detected for 20 seconds. Eco Mode reduces power consumption
during quiet times while keeping you connected to your baby. In ECO
mode the ECO LED light is green and the device will operate on a different
connection modus. In ECO mode the parent unit uses the 2 seconds
ping mechanism to check the connection with the baby unit instead of a
continuous radio frequency connection. Therefore the Baby Unit will also
consume less energy in ECO mode.