GreenWorks MO48L4212 Manual Del Operador página 13

9.4 VERTICAL STORAGE
1. Remove the grass catcher.
2. Remove the battery and safety key.
3. Pull and turn the handle knobs 90.
4. Fold down the handles.
5. Turn the handle knobs 90° to lock the handle into
position.
6. Stand the machine on end and make sure that the brackets
touch the floor.
10 TROUBLESHOOTING
Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
English
Problem
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
Solution
during mowing.
Adjust the height
of the handle and
make sure that the
bolts and nuts are
aligned correctly.
13
Possible cause Solution
The battery ca- Charge the battery
pacity is low. pack.
The start handle is Replace the start
defective. handle.
The battery key is Put in the battery
not put in. key.
The lawn is rough. Examine the mow-
ing area.
The blade height is Move the wheels
not set correctly. to a higher posi-
tion.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade
tall, or the blade height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
The blade is un- Replace the blade.
balanced and
worn.
The motor shaft is 1. Stop the mo-
bent. tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
The blade height is Increase the blade
too low. height.
The battery pack is Charge the battery
out of power. pack.
The grass clip- Remove the bat-
pings attach to the tery pack and
deck or the blade. check the deck.
Operation temper- Cool the machine.
ature of the ma-
chine is too high.
EN