Beurer 95261 Instrucciones De Uso página 32

6. Initial use
6.1 Preparing the device for first time use
Before the first use, the batteries should be fully charged� The charging pro-
cess lasts for approx� 4 hours� The device then offers an operating time of
approx� 8 hours� You will get the maximum capacity from your battery if you
run down the battery at least once every 6 months� To do this, disconnect
the device from the mains and run the battery down through normal use�
Afterwards, fully charge the battery again�
The maximum battery capacity can only be reached after it has been charged
several times and is dependent on many factors (battery state, ambient tem-
perature, manner and frequency of charging etc�)�
6.2 Initial use of camera
1� Place the camera on a level, firm surface and point the camera lens at the
area that you wish to monitor� Ensure that there are no other electrical de-
vices nearby�
WARNING
Do NOT position the camera within reach of the baby!
2� Connect the small end of the camera mains part plug to the camera� Con-
nect the other end of the camera mains part plug to a suitable socket�
3� Slide the ON/OFF switch at the top to "ON" to switch on the camera� The
function light on the camera lights up green�
4� Slide the ON/OFF switch to "OFF" to switch off the camera�
6.3 Initial use of parent unit with battery
1� Open the battery compartment lid on the rear of the parent unit by sliding
it sideways�
2� Slide the battery included in delivery into the
battery compartment with the gold +/- surface
going first and with the side with writing on it
facing upwards, as shown� Ensure that the bat-
tery is fully inside the battery compartment, as
far as it will go�
3� Close the battery compartment lid on the rear of the parent unit again, until
you can hear and feel it slot into place�
32