RIDGID R86712 Manual Del Operador página 8

OPERATION
MASONRY DRILLING
See Figure 9, page 12.
For maximum performance, use carbide-tipped masonry
impact bits when drilling holes in brick, tile, concrete, etc.
 Select Rotary Hammer Mode.
 Apply light pressure and medium speed for best results
in brick.
 Apply additional pressure for hard materials such as
concrete.
 When drilling holes in tile, practice on a scrap piece to
determine the best speed and pressure. Begin drilling at
a very low speed to prevent the bit from slipping off the
starting point.
WOOD AND METAL DRILLING
For maximum performance, use high speed steel bits for
wood or metal drilling. Select Rotational Drilling Mode.
Begin drilling at a very low speed to prevent the bit from
slipping off the starting point.
NOTICE:
When using the tool, do not apply too much
pressure. Too much pressure will place unnecessary
load on the motor.
WOOD DRILLING
 Select Rotational Drilling Mode.
 Increase the speed as the bit bites into the material.
 When drilling through holes, place a block of wood behind
the workpiece to prevent ragged or splintered edges on
the back side of the hole.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 9 AFTER FRENCH AND
SPANISH LANGUAGE SECTIONS. ILLUSTRATIONS START ON PAGE 10.
This product has a 90-Day Satisfaction Guarantee Policy, as well as a
Three-year Limited Warranty. For Warranty and Policy details,
please go to powertools.ridgid.com or call (toll free) 1-866-539-1710.
METAL AND STEEL DRILLING
 Select Rotational Drilling Mode.
 Use a light oil on the drill bit to keep it from overheating.
The oil will prolong the life of the bit and increase the
drilling action.
 Maintain a speed and pressure which allows cutting
without overheating the bit. Applying too much pressure
will:
• Overheat the tool;
• Wear the bearings;
• Bend or burn bits; and
• Produce off-center or irregular-shaped holes.
 When drilling large holes in metal, start with a small bit,
then finish with a larger bit.
CHISELING
See Figure 10, page 12.
 Select Chisel Only Mode.
 Position the tip of the chisel at the point where chiseling
is to begin.
 Apply light pressure and medium speed for best results in
brick or tile. Apply additional pressure for hard materials
such as concrete.
 Selecting Chisel Adjust Mode allows the bit to rotate
freely to the best operating position for your chiseling
application.
8 – English