Publicidad
Idiomas disponibles
Idiomas disponibles
From time to time, the App is updating automatically to the latest software. Also the Airfryer
is updating the firmware automatically.
Note
• When an update is being installed, make sure that your Airfryer is connected to the
home WiFi. The smart device can be connected to any network.
• Always use the latest App and firmware.
• Updates are made available when there are software improvements or to prevent a
security issue.
• A firmware update is started automatically when the Airfryer is in stand-by mode. This
update takes up to 1 minute and the screen on the Airfryer shows blinking "---". During
this time the Airfryer cannot be used.
Device compatibility
For detailed information about the compatibility of the App, please refer to the information
in the App Store.
Factory reset
For a factory reset of the Airfryer, press the temperature and time up buttons at the same
time for 10 seconds.
Your Airfryer is then no more connected to your home WiFi and not paired with your smart
device anymore.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying
RF exposure compliance. To maintain compliance with FCC RF exposure compliance
requirements, please follow operation instructions as documented in this manual. This
transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of
20 cm between the radiator and your body. The availability of some specific channels and/ or
operational frequency bands are country dependent and are firmware programmed at the
factory to match the intended destination. The firmware setting is not accessible by the end
user.
ENGLISH
7
Publicidad
