Husqvarna Z454 Manual Del Operador página 29

LUBRICATION
Engine oil change
NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations.
WARNING! The engine drain plug is near
to the muffler. To prevent burns, the engine
should be shut off and allowed to cool slightly
so the engine is still warm but the adjacent
surfaces and oil are not.
1. Park on a level surface. Engage park brake.
2. Clean the dirt and debris from the area around
the oil fill cap.
3. Remove the cap/dipstick.
4. Find the drain hose at the right rear of the
engine. Place a sufficiently sized container
under the end of the drain hose and remove
the oil drain plug.
5. Let the used oil fully drain from the engine.
6. Replace and tighten the drain hose plug.
7. Fill the engine with new oil to the bottom of
the fill tube threads. Check the level with the
dipstick.
8. Replace and tighten the oil fill cap when the
oil level is FULL.
9. To discard the used oil, refer to local disposal
regulations.
10. Refer to the Service Journal for oil checking
and changing intervals and change
recommendations.
Wheel and Deck Zerks
Use only good quality bearing grease. Grease
from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
set of wheel mounts.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck completely.
If a grease gun without rubber hose is used, the
foot plate must be removed to access the center
spindle.
Lubricate with a grease gun, 2-3 strokes per
spindle.
29