JENN-AIR 720-0336C Manual De Uso Y Cuidado página 14

3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe. To use the quick connect fitting; pull the
head of the quick connect back, insert the end of the PVC
gas hose and release the head of the connector. Check the
the connection is secure.
B
A
A. 10 ft. (3.0 m) PVC gas hose
B. Natural gas pressure regulator/hose assembly
C. Manifold
D. Right side panel
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the 2 screws that hold the burner in place. Set the
screws aside. Remove the burner from the grill by lifting the
burner out.
14
C
A
A. 2 screws
3. Use a 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifice from the end of gas valve. The main burner
orifice is located behind the LP orifice, so no additional orifice
needs to be installed.
D
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
4. Reinsert the burner and reattach using the 2 screws
previously removed. Repeat the procedure for each main
burner.
5. Position the igniters so they are ¼" (6.0 mm) away from each
burner.
Change the Rotisserie/Infrared Burner Orifice
1. Using a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle.
A
A. Main burner orifice
A. Wind baffle
A