Stihl FSE 60 Manual De Instrucciones página 29

8 Mounting the Cutting Attachment
4
► Fit the locknut (3) in the hex recess on the
deflector.
► Make sure the holes line up.
► Insert the M6x30 screw (4) and tighten it down
firmly.
8 Mounting the Cutting
Attachment
8.1 Placing Power Tool on the
Ground
► Switch off the power tool.
► Lay your trimmer on its back with the loop
handle facing down and the output shaft facing
up.
8.2 Fitting Mowing Head without
Screw Mounting
Keep the supplement sheet for the mowing head
in a safe place!
0458-282-9821-C
8.2.1
3
2
► Slip the mowing head (2) on to the shaft – as
AutoCut 5-2.
► Turn the spool (9) clockwise until the two
arrow heads line up – secure the spool in this
position.
► Insert the cap (8) in the spool, press it down
as far as stop and turn it clockwise at the
same time.
► Turn the cap until you feel resistance and then
tighten it down firmly by hand.
8.2.2
► Place the mowing head (2) on the shaft (3)
while inserting the internal hexagon (2) on the
hexagon (4)
► Hold the mowing head (2) with your hand.
► Turn cap (1) clockwise and tighten it firmly by
hand.
STIHL AutoCut C 5-2
8
9
STIHL AutoCut C 6-2
English
1
2
3
4
29