Worx WX272 Manual De Instrucciones página 11

working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
This tool is intended for the fastening and loosening of
bolts, nuts and various threaded fasteners. This tool is not
intended for use as a drill.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the Battery Pack
Charging the Battery
Installing the Battery Pack
Checking the battery condition
NOTE: Fig. A4 only applies for the battery
pack with battery indicator light.
ASSEMBLY
Inserting and Removing Socket (not
supplied)
NOTE: Make sure the battery is removed
before changing accessories.
NOTE: Use only sockets designed for
impact wrenches. Always select the
correct size impact socket for nuts and
bolts.
Assembling the belt hook
OPERATION
Switch Lock
Set the direction of rotation selector
in the OFF (center lock) position
to lock the switch trigger and help
prevent accidental starting when not
in use.
20V Brushless Impact Wrench
Forward And Reverse Rotation Control
WARNING: Never Change The
Direction Of Rotation When The
Chuck Is Rotating, Wait Until It Has
Stopped!
Variable Speed Control
The variable speed switch trigger
delivers higher speed with increased
trigger pressure and lower speed
with decreased trigger pressure.
To turn the tool ON, depress the switch
trigger. To turn it OFF, release the switch
trigger and allow the anvil to come to a
complete stop
The tool has the reverse rotation
auto stop mode which works only
with pulling the trigger fully in
counterclockwise tool rotation.
Operating the On/Off Switch
WARNING: Do not operate for
long periods at low speed
because excess heat will be
produced internally.
FIGURE
Using The LED Light
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed, and will automatically
See Fig. A1
turn off 20 seconds after the On/Off
switch is released.
See Fig. A2
The tool and battery are equipped with a
protection system. When the LED Light
is quickly flashing 3 seconds and turn
See Fig. A3
off, the system will automatically cut off
power to the tool to extend battery life.
The tool will automatically stop during
See Fig. A4
operation if the tool and/or battery
are placed under one of the following
conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw an
abnormally high current. In this situation,
release the Trigger Switch on the tool
and stop the application that caused the
tool to become overloaded. Then pull the
Trigger Switch again to restart.
See Fig.
• Overheated: Under the condition
B1, B2
above, if the tool does not start, the
Tool and Battery are overheated. In this
situation, let the Tool and Battery cool
before pulling the Trigger Switch again.
• Low battery voltage: The remaining
Battery capacity is too low and the tool
See Fig.
will not operate. In this situation, remove
C1, C2
and recharge the Battery.
WARNING:
To turn on the light, press the On/
Off switch and make sure the Forward/
Reverse Rotation Control is on right/left
position.
See Fig. D1
See Fig. D2,
D3
See Fig. E
See Fig. F
11
See Fig. F
EN