Publicidad
Idiomas disponibles
Idiomas disponibles
EN
How To oPERATE yoUR
ComPRESSoR
NOTE– Before initial operation, your nebulizer should be
cleaned following cleaning instructions, or as
recommended by your physician or DeVilbiss provider.
1.
Make sure the power switch is in the "Off" position
(Fig. 1) and unwrap power cord.
2.
Place compressor so that the rubber feet are resting on
a level, sturdy surface (Fig. 2) and upon which the
controls can be easily reached when seated. Never
block the air openings of the product or place it on a
soft surface, such as a patient's lap or a bed or couch
where the air openings may be blocked.
3.
Plug power cord into an appropriate wall outlet.
� danger
DeVilbiss compressor/nebulizer must be
operated on the specified power source to avoid
risk of electric shock and damage to the
compressor .
4.
Wash hands.
5.
Connect one end of the nebulizer tubing to the
compressor air-outlet connector (Fig. 2).
NOTE– During high-humidity weather conditions, condensation
(water build up) can occur in the nebulizer tubing.
6.
Assemble clean nebulizer parts by placing baffle down
in medication cup. Add prescribed medication into the
medication cup (Fig. 3). Holding cup stationary, screw
on nebulizer cap (Fig 4).
7.
Assemble mouthpiece, t-piece, and corrugated tubing
(if applicable) and insert into the top of the nebulizer
cap. If using an aerosol mask, insert the bottom part of
the mask directly into the top of the nebulizer cap.
8.
Attach tubing to nebulizer air-inlet connector (Fig. 5).
9.
Press the power switch "On" (Fig. 1) to start the
compressor.
10. Begin treatment by placing the mouthpiece between
teeth. With mouth closed, inhale deeply and slowly
through mouth as aerosol begins to flow, then exhale
slowly through the mouthpiece (Fig. 6). If treatment
needs to be interrupted, simply press power switch
"Off."
A-655
6
How to operate
Figura 1
Figure 2
Figure 3
Figure 4
Publicidad
