Publicidad
SERVICING REQUIREMENTS
General Notes
Use the following lubricants:
● Grease - molykote Longterm W2 for splines
and guide rod.
● Grease - Molykote G68 for Gearbox.
● Grease - Molykote PG75 Plastislip for
O-Rings.
● Grease - BP FGOOEP for Cylinder bore.
Cleaning
Requirements:
(1) Container to immerse components.
(2) Good quality clean paraffin.
● Soak the components in the container
containing the paraffin.
● Ensure full immersion, agitate components to
ensure that air passages are flushed through.
● Remove components from the container,
thoroughly dry and blow through air passages
to remove moisture.
● Place components in an air tight container
until required for assembly.
● Dispose of the dirty paraffin in accordance
with health and safety regulations.
MAINTENANCE INSTRUCTIONS
The bearing sleeve complete is under
spring (19) compression. whilst
resisting the thrust due to the spring
(19), carefully unscrew and remove
the bearing sleeve complete followed
by the spring.
● Service should be carried out at intervals of
1000 hours'use. Always quote tool model
number, serial number and spare part number
when ordering spares.
● All torque figures ± 5%.
● Dismantle the tool using the exploded view.
● Clean all components and inspect for wear or
damage, exchange if necessary.
● Apply new lubricant to the relevant parts in
accordance with list.
● Replace the front seal after dismantling the tool.
● Special tools shown in exploded view are in
addition to normal workshop tools.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
Protective gloves and eye protection
should be worn during cleaning of parts.
Eating or smoking is prohibited when
cleaning, dismantling or assembling tool.
03/2015
441483
Issue no : 10
Series : C
25 / 72
Publicidad
