Inserting The Batteries - AEG FMI 5509 Instrucciones De Servicio

Remote Control
Button a = „BUBBLES & KEEP WARM"
Bubble + Heated footrest
Button b = „MASSAGE" Massage
Button c = „HEAT" Heat fi eld
Button d = „Off " Off

Inserting the Batteries

NOTE:
The lithium cell in the battery compartment of the re-
mote control has been secured for transport with a foil.
This prolongs the lifetime of the battery. Before initial
use please remove this foil so that the remote control is
ready for operation.
The battery of the remote control is a long-life lithium
cell. If the range of the remote control is reduced during
use, please proceed as follows:
• Open the battery compartment on the back of the
remote control.
• Replace the cell by a battery of the same type (CR
2032). Ensure correct polarity.
• The „+" pole must be on top.
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid
leaking.
CAUTION:
Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
WARNING:
• Do not expose the batteries to high temperatures
or direct sunlight. Never throw batteries into the
fi re. There is a danger of explosion!
• Keep batteries away from children. They are not a
toy!
• Do not open the batteries by force.
• Avoid contact with metallic objects. (Rings, nails,
screws et cetera.) There is a danger of short-circui-
ting!
• As a result of a short-circuit batteries may heat up
considerably or even catch fi re. This may result in
burns.
• For your own safety the battery poles should be
covered with adhesive strips during transport.
• If a battery leaks do not rub the liquid into your
eyes or mucous membranes. If hands come into
contact with the liquid they should be washed
thoroughly and eyes rinsed out with clear water; if
symptoms persist please consult a doctor.
05-FMI 5509 AEG.indd 27 05-FMI 5509 AEG.indd 27
Use
Dry massage
The device can be used for a short time without water
for massaging the feet.
WARNING:
During the dry massage the device may only be opera-
ted in the "MASSAGE" position.
Wet massage
In order to enjoy a wet massage, fi ll the device with
warm water.
Footbath
• Place the appliance on the fl oor so that you can sit
comfortably in front of it.
• Fill the device with cold or warm water. Do not fi ll
past the maximum mark (see inner wall (MAX), below
the massage knobs). Make sure that the mains plug is
not inserted before you fi ll the device.
• Only connect the machine to a properly installed
safety socket, 230 V/50 Hz.
• Sit down and put your feet in the appliance.
• Set the mode of operation.
Press the switch on the device once in order to access
the following settings:
• „BUBBLES & KEEP WARM"
Bubble + Heated footrest
• „HEAT" Heat fi eld
• „Off " Off
• „MASSAGE" Massage
NOTE:
• With the remote control the same functions
can be adjusted. (Overview of the operating
controls)
• The settings can be combined with one another,
e.g. „MASSAGE" and „BUBBLES & KEEP WARM".
• Enjoy a deep, penetrating massage by moving your
feet backwards and forwards over the refl ex zone
knobs.
• You can also use the massage rollers supplied. Attach
the rollers in the recesses/holes provided on the
bottom. Please ensure that they lock into place. The
rollers can be removed for cleaning. Grip the roller
with your thumb and index fi nger and pull it out.
Heat fi eld function
• Press the „HEAT" button to switch on the heat fi eld.
• Place one foot on the central console. Exert more or
less pressure as you please.
English
27
10.09.2008 14:23:04 Uhr 10.09.2008 14:23:04 Uhr