Publicidad
Idiomas disponibles
Idiomas disponibles
54 TROUBLESHOOTING
Error Codes
Problem
Error code: tE1 through
tE7
Display shows error
code: PS (electric
dryers only)
TM
*Flow Sense
indicator
shows four bars during
the drying cycle or the
display shows "d80"
after drying
* This warning light
is not a dryer failure
and is not covered by
the dryer warranty.
Contact a duct cleaning
service to set up an
appointment to have
your exhaust system
cleaned and inspected.
TM
The Flow Sense
indicator remains
active after clearing
the restriction in the
venting.
indicator light is on
during the drying cycle
Possible Cause
Temperature sensor failure.
Power cord is connected
incorrectly.
Exhaust system is too long or
has too many turns/restrictions.
Partial blockage of the ductwork
due to lint buildup or other
foreign object.
The appliance has detected a
restriction in the external dryer
venting.
After clearing the restriction, the
TM
Flow Sense
system requires
multiple, consecutive cycles to
determine that the performance
value has improved before the
TM
Flow Sense
indicator is reset.
Lint filter not cleaned properly.
Solutions
Turn off the dryer and call for service.
Check the connection of the power cord
to the terminal block.
Install a shorter or straighter duct run. See
the Installation Instructions for details.
Ductwork should be checked/cleaned
immediately. Dryer can be used in this
condition, but drying times will be longer
and energy consumption will increase.
If exhaust restrictions are sensed by the
TM
Flow Sense
system, the indicator will
remain on for 2 hours after the end of the
cycle. Opening the door or pressing the
POWER button will turn off the display.
TM
If the Flow Sense
indicator remains
active for more than five cycles after
the restriction has been cleared, call for
service.
Remove the lint from the filter before
every load. With the lint removed, hold
the filter up to a light to see if it is dirty or
clogged. If it looks dirty, follow the cleaning
instructions. With some loads that produce
high amounts of lint, it may be necessary
to clean the filter during the cycle.
Publicidad
