Publicidad
Idiomas disponibles
Idiomas disponibles
PAD ASSEMBLY CONTINUED
• Hold the spindle lock (B) and insert the threaded post (J) of
the sanding pad into the drive spindle (c).
• Tighten the sanding pad (D) by spinning it clockwise until
secure.
• Place desired sandpaper onto the sanding pad (D).
D
C
J
B
noTe: Only use approved self-adhesive type sandpaper.
• Push the spindle lock (B) on the designated
"PuSh
unLocK" side so the locking tab (K) is no longer
in the side hole of the drive spindle (c).
IMPorTAnT: The tool MUST be in the unlocked position for
orbital action.The Spindle Lock is for attaching and removing the
sanding pad only. The tool MUST be in the lock position to install
sandpaper pad. Do not operate
the tool with the spindle lock
in the locked position or the
sander will stall when pressure
is applied to the pad.
• Set the speed control
dial (e) to the desired
variable speed.
• Ready for use.
D
C
B
Increase
Speed
Reduce
E
Speed
PAD REMOVAL
• Disconnect the sander from the air supply before removing
the Sanding Pad (D).
• Position the locking tab (K) of the spindle lock (B) so that it
lines up with the side hole on the drive spindle (c).
• Push the spindle lock (B) in order to insert the locking tab (K)
into the drive spindle (c). This will prevent the drive spindle (c)
from rotating.
• Hold the spindle lock (B) and rotate the sanding pad (D)
counterclockwise to unthread the post (J) of the sanding pad
from the drive spindle (c).
• When the sanding pad (D) becomes loose enough, it may be
removed from the drive spindle (c).
C
B
K
OPERATING PROCEDURES
Start-up (Fig. 1, pg. 2)
• Connect the tool to air source with the hose of recommended size.
• Turn on the air compressor and allow the air tank to be filled.
• Set the air compressor regulator to 90 PSI. This air
tool operates at a maximum of 90 PSI air pressure.
• Depress the trigger to start operating the tool.
13
D
C
B
Publicidad
