Troubleshooting - Klarstein 10030921 Manual De Instrucciones

Stage 2
• Drain the cleaning solution from the internal reservoir by removing the rear drain cap and plug.
• Add fresh water to the Max. permit water volume line.
• With the stand-by mode, keep pressing ON/OFF button at least 5 seconds to activate the self-clean mode
again which will now act as a rinse.
• Upon completion of this final stage of the self clean process, the unit automatically changes to stand-by
mode. Proceed to drain the water from the internal reservoir by removing the rear drain cap and plug. Leave
the lid on the ice maker open to allow it to air dry.
NOTE: Please note if there is a water shortage during Self-cleaning mode, the unit will automatically go into
stand-by mode; If water bucket is fail to turn over, icon
for more than 5 seconds to release self-cleaning mode to change for other operations.
Cleaning and stop use.
• Make sure to unplug the appliance before cleaning and long time off use.
• Use a damp cloth to clean both the interior and exterior of the appliance.
• Water tank cleaning.
• Unscrew the nut of water outlet, drain off the water.
• Pour clean water into the water tank, use a clean cloth to wipe water tank around. Pour clean water again
until the flowing out water is clean, and then drain off water and grip the nut.
• Do not use organic solvents, boiling water, cleaning agents, strong acids, strong acid and Alkali etc substan-
ces for cleaning.
• If ice machine will be off use for a long time, you should unplug the appliance, drain off the water and dry
the appliance with a clean cloth, store the ice maker in a clean place.
Faults
WORK indicator is not
light.
ICE FULL indicator
is light.
Malfunction indicator
light flashes.

Troubleshooting

Reason Treatment
Power Source is not Check the power supply matches
switched on.
Check the power cord is connected correctly
Internal components are damaged. Maintenance in
professional department.
Ice fullness. Remove the full Ice cube.
Low-temperature Move the Ice maker to a warmer place, where the ambient
protection temperature is higher than 5°C.
(temperature is lower
than 5°C).
Ice making box reset Check whether any foreign body stuck the ice making box.
in bad condition.
Internal components are damaged. Maintenance in
professional department.
will be on, you need to long press ON/OFF button
12