Descargar Imprimir esta página

Weber 89478 Guia Del Propietario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

m danGer
when the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. after
turning off the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
4)
Insert match holder with lit match into the matchlight hole in the front of the
cooking box.
m warninG: do not lean over open barbecue. Keep your face
and body at least one foot away from the matchlight hole
when lighting the barbecue.
5)
Push BURNER 1 control knob down and turn to START/HI.
6)
Check that the burner is lit by looking through the matchlight hole on the front of
the cooking box. You should see a flame.
m warninG: if the burner does not light in five seconds, turn
the burner 1 control knob to off and wait 5 minutes to let
the gas clear before you try again.
7)
After BURNER 1 is lit you can turn on BURNER 2 (and BURNER 3).
Note - Always light BURNER 1 first. The other burners ignite from BURNER 1.
to eXtinGuish
Push down and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.
liGhtinG the side burner
m danGer
failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive flame-up which can
cause serious bodily injury or death.
m warninG: Check hose before each use of barbecue for
nicks, cracking, abrasions or cuts. if the hose is found to
be damaged in any way, do not use the barbecue. replace
using only weber
authorized replacement hose. Contact
®
the Customer service representative in your area using the
contact information on our web site. log onto www.weber.
com
.
®
1)
Open the side burner lid.
2)
Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the "OFF" position), turn all burners not being
used to the "OFF" position (push in and turn clockwise).
m warninG: the burner control knobs must be in the off
position before turning on the liquid propane cylinder
valve. if they are not in the off position, when you turn on
the lp cylinder valve, the "excess gas flow control" feature
will activate, limiting the flow of gas from the lp cylinder.
if this should occur, turn off the lp tank valve and burner
control knobs. start over.
www.weber.com
®
operatinG instruCtions
maiN bUrNer maNUal liGHTiNG
5
* the grill illustrated
may have slight
differences than the
model purchased.
when the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. after
turning off the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the barbecue. failure to do so may result in an explosive
flame-up, which can cause serious bodily injury or death.
2
1
4
6
320
m danGer
15
15
2
7
5
3

Publicidad

loading