Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing for installation
Note: The estimated installation time is 120 minutes. This
product can only be installed by a certified electrician Ca-
refully separate the fan's parts, avoiding the use of cutters
or blades that could scratch any part of it.
Remove the fan from the packaging carefully, avoiding the
use of knives which could scratch any part of it.
Remove all the components. Place the motor on a cloth or
wet surface so as not to damage its surface finish. Carefully
handle the unit to make sure that its casing does not bend
or get scratched.
The fan must be mounted on the floor or a large enough
table to prevent any component from falling off.
Instructions for synchronizing the
receiver and the remote control
The control is already factory-linked with its receive.
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
The control of this fan have two mode of synchronization,
Universal mode and Unit mode:
- Unit Mode:
This type of synchronization allows you to control two or
more nearby fans independently, each with its remote con-
trol.
Synchronization:
The control of this fan does not require synchronization
with the receiver, the control is already factory-linked with
its receiver
- Universal Mode:
This type of synchronization allows you to control one or
more nearby fans with the same remote control.
Synchronization:
1.-Connect the power (wall switch) of the fan or fans that
you want to control, and then just within the following
15 seconds, press the key
continuous seconds.
2.-Now, transmitter and receiver of the fan / s will have
been synchronized. Turn off the fan / s current using the
switch or automatic and then turn it back on / s, this step
is the one that closes the synchronization process.
It is not possible for a controller to forget a fan once it has
been linked, if you want a fan to leave
to obey a command, another one must be linked to
"overwrite it".
ATC: 916749481 - info@sulion.es / SAT : 916749483 - sat@sulion.es
of the remote control for 10
Remote control
Turn off
the fan
Change
Yellow
color
temperature
2
Speeds
1
2H
*Timer: If any button is pressed after a shutdown program
has been selected, it will be cancelled.
Light color temperature change
You can change the color temperature of the light, turning
off and on, with the wall switch, the remote control or in
case of being an IoT fan from your terminal.
OFF
NEUTRAL
ON
WARM
OFF
Memory function
OFF
WARM
OFF
WARM
Turn on/off
the light
White
Blue
3
4
Summer
5
6
4H
Nature wind
ON
OFF
COLD
ON
ON
NEUTRAL
ON
>20"
WARM
www.sulion.es
/Winter
Timer*
13
Publicidad
