Cameo CLZW600-D Manual De Usuario página 8

CONFIGURING STANDALONE MODE
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "Stand Alone" (observe
arrow) and confirm with ENTER. Now use UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER.
The display will now show a three-digit number field, and you can use UP and DOWN to configure the desired value between 000 and 255.
Confirm by pressing ENTER. Press MODE twice to return to the main display (Static Mode).
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
Systems Info
SET SLAVE MODE
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "Slave" (observe
arrow) and confirm with ENTER. Connect the slave and master units (same model) using a DMX cable and enable standalone mode on the
master unit. The slave unit will now follow the master unit. If there is no control signal, the display characters will flash. Flashing stops as
soon as a control signal is present.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
SYSTEM SETTINGS (settings)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "Settings"
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the sub-menu for configuring the following sub-menu items (select using UP and DOWN, confirm with ENTER):
Settings
Wireless Setting = W-DMX settings
(wireless DMX)
8
------------ Stand Alone ------------
Dimmer <255>
Strobe <255>
Duration <255>
Mode
Slave
W-DMX on/off
Operating Mode
Transmitting Mode
Link
Receive Reset
000
Mode
-
Static
255
On = W-DMX enabled
Off = W-DMX disabled
Receive = W-DMX module as receiver
Transmit = W-DMX module as transmitter
G3 = G3 transmission standard
G4S = G4S transmission standard
Link = pair with W-DMX devices. W-DMX must be activated on
all devices and the pairing must be picked up by a transmitter
(Receive Reset).
Unlink = unpair all devices
No = Do not retain transmitter pairing
Yes = Retain transmitter pairing