Cameo CLZW600-D Manual De Usuario página 9

Display Reverse = Flip display
Display Backlight = Display lighting
DMX Fail = operating status
when DMX signal
fault occurs
Dimmer Curve = dimmer curve
Dimmer Response = dimmer sensitivity
Autolock = Automatic locking
of the controls
LED Frequency = LED PWM fre-
quency
Fan = adjust fan control
Factory Reset = reset to factory
setting
Dimmer curves
linear
DMX value
On
Off
On
Off
Hold
Blackout
Full On
Stand Alone
Linear
Exponential
Logarithmic
S-Curve
LED
Halogen
On
Off
800 Hz / 1200 Hz /
2000 Hz / 3600 Hz
/ 12 kHz / 25 kHz
Auto
Max. Intensity
Low Noise
Reset Now!
exponential logarithmic
DMX value
DMX value
Rotate display by 180° (e.g. for overhead installation)
No display rotation
on permanently
Deactivation after approximately 1 minute of inactivity
Last command is retained
Activates blackout
Spotlight changes to full on
Spotlight changes to standalone mode
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX values and
broadly adjusted at higher DMX values.
Light intensity can be broadly adjusted at lower DMX values and
finely adjusted at higher DMX values.
Light intensity can be finely adjusted at lower and higher DMX
values and broadly adjusted at medium DMX values.
Lamp responds abruptly to changes in DMX value
Lamp behaves like a halogen spotlight with soft brightness
changes
Automatic locking of the controls after approximately 1 minute of
inactivity. After attempted input the display shows: "Locked!"
To unlock: press and hold UP and DOWN simultaneously for
approx. 5 seconds
Automatic locking of the controls is disabled
Set the LED PWM frequency
Automatic adjustment of the fan performance
Maximum fan capacity for maximum brightness
Extra-quiet fan with reduced brightness
Reset to factory settings:
ENTER -> "Reset Now!" -> ENTER. Press MODE to stop.
S-curve
DMX value
9