RIDGID R8647 Manual Del Operador página 8

OPERATION
METAL CUTTING
See Figure 12, page 10.
You may cut metals such as sheet steel, pipe, steel rods,
aluminum, brass, and copper with the saw.
Observe the following tips when metal cutting:
 Be careful not to twist or bend the saw blade.
 Place the orbital action selector in the linear stroke posi-
tion (OFF).
 Do not force the tool and use a slow speed.
 Use cutting oil when cutting soft metals and steel. Cutting
oil also keeps the blades cool, increases cutting action,
and prolongs blade life.
MAINTENANCE
WARNING:
When servicing use only identical replacement
parts. Use of any other parts can create a hazard
or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
To avoid serious personal injury, always remove
the battery pack from the tool when cleaning or
performing any maintenance.
NOTE: ILLUSTRATIONS START ON PAGE 9
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-day Satisfaction Guarantee Policy,
For Warranty and Policy details, please go to powertools.ridgid.com
as well as a Three-Year Limited Warranty.
or call (toll free) 1-866-539-1710.
 Never use gasoline since normal sparking of motor could
ignite fumes.
 Clamp the workpiece firmly and cut close to the clamping
point to eliminate any vibration of the work. When cutting
conduit pipe or angle iron, clamp the workpiece in a vise
if possible and cut close to the vise. To cut thin sheet
material, "sandwich" the material between hardboard or
plywood and clamp the layers to eliminate vibration and
material tearing.
 Always keep firm pressure on the shoe assembly to hold
it securely against the workpiece.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which can
result in serious personal injury.
8 - English