LG LSWC307 Serie Manual Del Propietário página 52

52 MAINTENANCE
8
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
9
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the soiled
areas.
If stubborn soils remain after multiple
®
EasyClean cycles, run the Self Clean cycle. Be
sure that the oven cavity is empty of oven racks
and other accessories, and that the oven cavity
surface is dry before running the Self Clean
cycle. Consult the Self Clean section of your
owner's manual for further details.
NOTE
• The cavity gasket may be wet when the
®
EasyClean cycle finishes. This is normal. Do
not clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.
• It is normal for the fan to operate during the
EasyClean ® cycle.
• It is normal to hear the sound of boiling water
from the steam generator while running the
®
EasyClean cycle.
• Using commercial oven cleaners or bleach to
clean the oven is not recommended.
Instead, use a mild liquid cleanser with a pH
value below 12.7 to avoid discoloring the
enamel.
Water Tank
The water tank is used during the steam cooking
functions. Use filtered, softened water if possible.
NOTE
• After using the steam function, the water tank
should be drained. To avoid bacteria or odors,
clean and dry the water tank after every use.
• Do not clean in a dishwasher.
Hard Water Scale
If hard water is used in the water tank, the steam
generator may become clogged with hard water
scale. In areas with hard water, run the Descaling
function frequently or use softened water.
Cleaning Scale on Oven Bottom
To remove mineral deposits that remain on the oven
bottom after using the steam mode, use a cloth
or sponge soaked in vinegar or a weak citric acid
solution. For more stubborn or extensive scaling, use
the Descaling function.
Descaling
Use this function to remove the white deposits that
form after the steam generator is used for a long
period.
The Descaling function runs for 1 hour 43 minutes.
Water will come out of the steam generator while it is
being cleaned.
For instructions on removing and filling the water
tank, see "Using the water tank."
Using Descaling
1
Fill the water tank with a 20:1 mixture of water
and citric acid. For example, use 4 tsp of citric
acid in 4 / cups water (20 g citric acid in 1000
1
4
ml water).
2
Insert the water tank into the slot over the oven
cavity and push it in until it clicks into place.
3
Touch More Mode.
4
Touch 4 to select DESCALING.
5
After a few minutes of descaling, TO START
RINSING, REPLACE THE WATER IN WATER
TANK WITH CLEAN WATER AND PRESS
START will appear in the display. Following the
instructions, drain the tank and fill it with clean
water.
6
Insert the tank and start the Rinsing function.
7
Once the Rinsing function is complete, dry the
inside of the oven with a soft cloth.
NOTE
• The Rinsing function must be completed even if
the Descaling function is canceled.
• For proper oven maintenance, run the entire
Descaling function without cancellation.
• The Rinsing function must be completed even if
the Descaling function is canceled.
• Descaling cannot be canceled while setting,
resetting, or pausing the upper oven.