outlet correctly.
The water line (1/4") length should be
less than 5m. If the water line is too long
(>5m), the ice and cold water content may
be affected due to insufficient water
pressure.
5. After connecting the water supply, water
filter,
and
the
connecting system layout shows below.
Note:
It is recommended to employ a qualified
person to install the water system.
If you have to repair or disassemble the
water line, cut off the ends of water line
(1/4") to make sure you get a snug,
leak-free connection.
refrigerator,
water
12
Warning!
After turning on the shutoff valve, make
sure that there is no leakage at all
connection points of the water lines.
If there is a leakage, turn off the shutoff
valve
immediately
connector or make the water lines fully
inserted into the connector.
Flush one gallon of water (approximately
five minutes) through the filter before
drinking or using the water from your
refrigerator.
--To flush, press a large glass or cup
against the water dispenser lever. Fill the
glass, then empty it into the kitchen sink.
--Repeat until you dispense about one
gallon of water.
The first time you use the water
dispenser, you may hear the sound of
water pushing air out of the water
dispenser. This is normal.
After powering on the refrigerator, let the
ice maker make ice for one to two days,
then throw out the first one or two buckets
of ice to make sure that all impurities have
been removed from the water lines.
Do not pull hard on the water lines, it may
damage the water system.
The water line should not be pressed by
heavy things and should not bend too
much.
and
tighten
the