KTC RT-68WC Manual De Instrucciones página 9

CAUTIONS:
Make sure that you:
Use the tubing that came with your
refrigerator and
installation kit. Do not use old tubing.
Connect to the cold-water pipe. If you
connect to the hot water pipe, the purifier
may malfunction.
Connect with the drinkable water only.
Do not contaminate the water pipes
during installation.
1. Shut off the main water supply.
2. Using a 1/4" drill bit, drill a hole into the
cold water line, then install the saddle-type
shutoff valve.
the water supply
9
3. Connect the water line installation kit
(not included) to the shutoff valve.
4. Turn the main water supply back on,
then turn on the shutoff valve and flush out
the tubing until the water runs clear.
Note:
The initial dark discoloration of water is
normal.
5. Turn off the shutoff valve.
Connecting the water supply to filter
inlet
You need to purchase several items to
complete this connection. You may find
these items sold as a kit at your local
hardware store.
You can use plastic tubing, copper tubing,
or stainless steel tubing as the water line
installation kit.
PLASTIC COPPER
TUBING TUBING
 1/4" plastic
 1/4" copper
tubing
→molded
tubing
end (bulb)
 1/4"
 1/4"
compression
compression
nut (1)
nut (1)
Ferrule (2)
STAINLESS
STEEL
TUBING
 1/4" copper
tubing
 1/4"
compression
nut (1)