Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
Never turn the ribbon cassette's feed knob in the opposite direction of
the arrow marked on the cassette; otherwise the ribbon cassette may
be damaged.
1.
Turn the printer on, and open the front cover by pulling up the tab on the
left side.
2.
Be sure the print head is on the right side.
3.
If a ribbon is already installed, remove it by grasping the end of the tab
and removing it from the printer.
4.
Turn the cassette knob on the
cartridge in the direction of the arrow
2 or 3 times to remove any slack.
5.
Insert the ribbon, and rotate the
cassette knob 2 or 3 more times, as
shown in illustration
6.
Make sure the ribbon has no wrinkles
or creases and is installed below the
print head as shown on the label
inside the printer.
Inserting Slip Paper
Note:
Use only slip paper that matches the specification. Do not
use wrinkled or curled paper.
When the SLIP LED flashes, insert slip paper,
1.
using the right edge of the slip paper inlet as a
guide (see illustration 4).
2.
When you insert the slip into the inlet as far as it
will go, the sensor detects the slip, the SLIP LED
changes from flashing to on, and the printer
draws the paper in and prints it.
After printing is complete, the SLIP LED goes
3.
off, and you can remove the slip.
Troubleshooting
No lights on the control panel
Check that power supply cables are plugged into the printer, the power unit,
and power outlet correctly.
The printer sounds like it is printing, but nothing is printing
Check that the ribbon cassette is installed correctly.
Replace the ribbon cassette.
3
.
TM-U590/U590P User's Manual 7
English
3
4
1
2
Publicidad
