Metabo SSD 18 LT 200 BL Manual Original página 11

2) Stepless adjustment of the tightening torque:
The speed and tightening torque can be adjusted
steplessly in any torque setting by pressing the
trigger (5) firmly or lightly, thus adapting to working
conditions.
Recommendation: determine the correct setting
by carrying out trial screwdriving.
6.5 Changing SSD screwdriving bits
Inserting screwdriving bit: Slide locking sleeve
(3) forward and insert screwdriving bit as far as the
stop. Release locking sleeve (3) .
Pull on the screwdriver bit to check that it is
correctly seated.
Removing screwdriving bit: Slide locking sleeve
(3) forward and remove screwdriving bit.
Only use screwdriving bits with such plug-in
ends:
The screwdriving bit used must match the
screw.
Damaged screwdriving bits must not be used.
6.6 Change screwdriving bit for SSW ...
Inserting screwdriving bit: Fit the tool on the
square attachment (1) until the limit stop.
Removing screwdriving bit: Pull the tool from the
square attachment (1).
The screwdriving bit used must match the
screw.
Damaged screwdriving bits must not be used.
7. Use
Mount the machine on the screw, ensuring it is
aligned straight.
The screwdriving process consists of 2 parts: insert
screw and
tighten screw with the impact mechanism.
The tightening torque depends on the impact
duration.
With an impact duration of approx. 5 seconds, the
maximum tightening torque has been reached.
The torque curve depends on the type of
application:
With a hard screwdriving application (screw-
couplings in hard material such as metal), maximum
9,5 mm (3/8")
tightening torque is already reached after a short
impact duration (a).
With a soft screwdriving application (screw-
couplings in soft material such as wood), a longer
impact duration (b) is required.
Recommendation: determine the correct impact
duration by carrying out trial screwdriving.
Caution! For small screws the maximum torque
can be reached already after
0.5 seconds impact duration.
- This is why the duration of the screwdriving
process must be monitored exactly.
- Set a (8) suitable tightening torque using the
button (see chapter 6.4).
- Adjust the tightening torque by pressing firmly or
lightly on the trigger (5), ensuring that the screw is
not damaged or that the screw head does not tear
off.
8. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
See page 4.
A Chargers
B Battery packs with different capacities
Use only battery packs with voltage suitable for
your power tool.
C Screwdriving bits
For a complete range of accessories, see
www.metabo.com or the catalogue.
9. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
10. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
ENGLISH en
11