Publicidad
Idiomas disponibles
Idiomas disponibles
Conducting a final test
Carry out a final submersion test on the waterproof case after mounting the digital
camera. To check for water leaks, watch for any water leaking in while immersing it in
a water tank or a bathtub filled with water. Check it in a way that lets you take it out of
water immediately (to save the camera inside) if you need to.
1
Immerse it in water for 30 seconds.
2
After slowly lifting the waterproof case out of water, closely check for
the following:
Water
droplets
Dip it slowly in
water.
Joint
• If you see a continuous flow of
air bubbles from the joint of the
waterproof case while in the water, this
indicates a leak.
• When all is well, operate the buttons
and take some test shots while it is
under water.
• Water droplets near the joint of the
waterproof case.
• Water pooled inside the waterproof
case.
EN-13
Publicidad
