Kärcher K 1 Manual De Instrucciones página 11

Description of the Appliance
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Illustrations on Page 2
1 High pressure connection
2 Appliance switch „0/OFF" / „I/ON"
3 Storage hook for high pressure hose
and mains connection cable
4 Carrying handle
5 Storage for spray lance
6 Hose coupling
7 Coupling element for water connection
8 Water connection with integrated sieve
9 Detergent suction hose (with sieve)
10 Mains cable with mains plug
11 Trigger gun
12 Lock trigger gun
13 Clamp for high pressure hose
14 High pressure hose
15 Spray lance extension
16 Spray lance with high pressure nozzle
Additionally required
Water supply hose
– Use a fabric reinforced water hose.
Minimum diameter, 1/2 inches (13 mm).
Minimum length 7.5 m.
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 2
Illustration
 Attach the transport handle.
Illustration
 Pull out the clamp for the high pressure
hose from the trigger gun.
Illustration
 Connect high pressure hose to trigger
gun.
 Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Illustration
 Screw the coupling element to the wa-
ter connection on the appliance.
 Park the appliance on an even surface.
Illustration
 Connect the high pressure hose to the
high pressure connection of the appli-
ance.
 Insert the mains plug into the socket.
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
For connection values, see type plate/tech-
nical data.
 Illustration
– Screw the supplied hose coupling on to
the end of your water supply hose.
– Attach the water supply hose to the
coupling on the water connection.
 Connect the water supply hose to the
water supply.
 Completely open the water tap.
– 7
EN
Assembly
Start up
Water supply
7