Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.6.Assembly
Steps to follow:
1.
Be sure that heater elements (washer of
silicone rubber, guide fitting and PBTP nut) are
in the order and position that the fig. 1 shows.
2.
Insert the heater through the screw mouth
(see fig. 2); hold the heater of the fitting (fig. 1,
piece 3) and turn the PTPB nut (fig. 1, piece 2)
Rev. 020113
Fig. 1
Fig. 2
3.
Place the condenser onto the vertical tube.
Be sure that the O-rings are on the surface of the
tube and connect the silicone tubes.
4.
Put the water inlet tube on the inlet still
(fig. 2, piece 6)
5.
Be sure of putting the filter, of tightening
and connecting the other end to the tap.
•
Once you have assembled, check:
-
The silicone tubes hold suitable position to
let water pass and to avoid water pressures.
Pag: 9
Publicidad
Tabla de contenido
